Instruction Manual

Operation, cont’d
MGP Series • Operation
3-18
PRELIMINARY
Recalling a background from memory
To recall an image from memory for use as a background,
1
. Press Menu repeatedly until the Background Capture screen is displayed.
2. Press Next repeatedly until the Recall Background from Memory submenu
screen is displayed.
3
. Rotate either Adjust knob to select one of background image files to recall for
use as the output background.
To perform no action, press the Menu button.
4. Press the Next button to recall the image. The LCD screen displays the
message “Recalling” while the image is being recalled, then “Recalled” after
the recall is complete.
Comm./IP Conguration menu
Use the Comm./IP Conguration menu to view and edit the serial communication
port conguration and the MGP’s IP addresses. The Comm./IP Conguration
menu consists of two levels: view and edit.
Viewing serial port and IP settings
When you rst reach the Comm./IP Conguration menu, you are on view level;
that is, all the screens that you cycle through by pressing Next show the current
settings. You cannot make changes from them. To view the serial port and IP
settings,
1
. Press Menu repeatedly until the Comm./IP Configuration menu is displayed.
2. Press Next repeatedly to cycle through the screens displaying the current
settings for the serial port, MAC address, DHCP mode, IP address, Gateway
address, and Subnet mask.
3
. Press Menu to return to the Comm./IP Configuration screen.
Making changes to the serial port and IP conguration
To make changes to the serial port conguration, IP address, DHCP mode, Gateway
address, and/or Subnet mask, you must access the edit level screens as follows:
1
. With any Comm./IP Conguration menu view-level screen displayed,
press the Enter button and hold it until the Serial Cong screen appears
(approximately 2 seconds).
2
. Press Next repeatedly to cycle through the edit level screens.
3. To enter or change information on each screen, rotate the horizontal Adjust
knob (
[
) to move the angle brackets to the desired setting. Rotate the
vertical Adjust knob (
{
) to adjust the setting.
4
. When nished editing the settings for the selected item, either press Next to
go to the editing screen for the next item, or press Menu to exit serial/IP edit
mode and go to the next menu (Advanced Configuration).
Screens are provided for editing the following parameters:
•
Serial Config: Configure the serial port by switching between RS-232 and
RS-422, and selecting the baud rate.
•
Set DHCP Mode: Set DHCP to On or Off.
N
DHCP must be off before you can edit the IP addresses.