Instruction Manual

5-5
MGP Series • HTML Conguration and Control
PRELIMINARY
Scaler I/O Settings page
On the Scaler I/O Settings page (shown below), you can specify configuration
settings for the 4 fully congurable inputs, the 15 virtual inputs, and the output.
You can also select a test pattern and enable or disable blue mode.
Scaler I/O Settings page
Conguring the inputs
The Input Configuration section of the Scaler I/O Settings page lets you name,
enable and disable film mode for 3:2 and 2:2 pulldown, and select the video signal
type for each of the 19 available inputs.
Naming inputs
You can assign names to the inputs using the input name boxes located beneath
each input number. The name in this box is displayed on the screen as a text label
in the window, unless you specify otherwise. (See “Window Settings page,” later in
this chapter.)
Initially, the default name Input## is displayed in each box.
N
If you select a virtual input that actually consists of two inputs (S-video) or
three inputs (YUVi), only the first input number of the set is displayed in the
window.
For example, if inputs 5, 6, and 7 have been configured together as a YUVi
input, only 5 appears as the input number on the screen.