Setup Guide User guide

CrossPoint / MAV Matrix Switchers • Introduction
Introduction
CrossPoint / MAV Matrix Switchers • Introduction
1-31-2
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com. Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
N
For more information on any subject in this guide, refer
to the CrossPoint 450 Plus / CrossPoint Ultra /
MAV Plus User’s Manual, available on the Extron disk
or at www.extron.com.
N
In this manual, the term “CrossPoint”, when “450 Plus”
or “Ultra” is not specified refers to either the
CrossPoint 450 Plus or the CrossPoint Ultra.
About this Manual
This setup guide allows you to easily and quickly set up and
congure your matrix switcher. Step by step instructions show
you how to connect the hardware. The guide also shows you
how to perform basic operations and use both the front panel
controls and selected Simple Instruction Set (SIS
) commands.
This guide also shows you how to load and start up the
Windows
®
-based Matrix Switchers Control Program. Lastly, this
guide shows you how to connect to the built-in HTML pages,
which you can use to operate the switcher.
About the Matrix Switchers
The Extron matrix switchers covered in this manual distribute
any input to any combination of outputs. The switchers can
route multiple input/output combinations simultaneously. The
switchers are available in a variety of matrix sizes (the number
of inputs and outputs).
The CrossPoint switchers are available in HV (RGBHV video)
and HVA (RGBHV video and audio) models.
The MAV Plus matrix switchers are available in the following
models:
HDA — • HDTV/component video and audio
HD — • HDTV/component video only
SVA — • S-video and audio
SV — • S-video only
AV — • Composite video and audio
AV RCA • Composite video and audio on RCA connectors
(128 size only)
V — • Composite video only
A — • Audio only
N
In this manual, the term “video model” refers to any
CrossPoint or MAV Plus switcher that switches video.
In this manual, the term “audio model” refers to any
CrossPoint or MAV Plus switcher that switches audio.
Figure 1-1 — Typical matrix switcher application