Setup Guide User guide

CrossPoint / MAV Matrix Switchers • Remote Control
Remote Control, cont’d
4-12
CrossPoint / MAV Matrix Switchers • Remote Control
4-13
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Accessing the HTML Pages
Another way to operate the switcher is via its factory-installed
HTML pages, which are always available and cannot be erased
or overwritten. The switcher’s HTML pages are accessible
through its LAN port, connected via a LAN or WAN, using a
web browser such as Microsoft Internet Explorer. See
i
on
page 2-6, for connection information.
Loading the start-up page
N
If your Ethernet connection to the matrix switcher is
unstable, try turning off the proxy server in your Web
browser. In Microsoft Internet Explorer, click Tools >
Internet Options > Connections > LAN Settings,
uncheck the Use a proxy server... box, and then click
OK.
N
For details on operating the switcher via HTML pages,
refer to the CrossPoint 450 Plus / CrossPoint Ultra /
MAV Plus Switcher Manual, chapter 6, “HTML
Operation”.
1
. Start the Web browser program.
2. Click in the browser’s Address eld.
3. Enter the Matrix IP address in the browser’s Address eld.
N
192.168.254.254 is the factory-specified default value for
this field.
4. Press the keyboard Enter key. The switcher checks to see if
it is password protected.
If the switcher is not password protected, it checks and
downloads the HTML start-up page. The switcher is ready
for operation via HTML remote control.
If the switcher is password protected, the switcher
downloads the Enter Network Password page.
N
A User name entry is not required.
5. Enter the appropriate administrator or user password in
the Password eld and click OK.
6. The switcher downloads the HTML start-up page. The
switcher is ready for operation via HTML remote control.