Setup Guide User guide

CrossPoint / MAV Matrix Switchers • Remote Control

Remote Control, cont’d

4-10

CrossPoint / MAV Matrix Switchers • Remote Control

4-11

Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.

4. Follow the on-screen instructions. The installation

program creates a C:\Program Files\Extron\

Matrix_Switchers directory and an “Extron Electronics\

Matrix Switchers” group folder. It installs the following

four programs:

• MATRIX Switcher+ Control Program

• MATRIX Switcher+ Help

• Uninstall MATRIX Switcher

• Check for Matrix Updates

Starting the program

1. Click Start > Programs > Extron Electronics > Matrix

Switchers > MATRIX Switcher + Control Pgm.

The Comm Port Selection window appears.

2. Choose the comm (serial) port that is connected to the

switcher or IP [LAN].

For a comm port, check the baud rate displayed in the

comm port selection window. If you need to change the

baud rate, click the Baud button and double-click the

desired baud rate.

Click OK.

If you selected a serial port in step 2, the Matrix Switchers

Control Program is ready for operation.

. If you selected IP [LAN] in step 2, the IP Connection

window appears.

a. Examine the Matrix IP Address eld, which displays

the last Matrix IP address entered.

If necessary, enter the correct IP address in the eld.

192.168.254.254 is the factory-speciﬁed default value for

this ﬁeld.

b. If the switcher is password protected, enter the

appropriate administrator or user password in the

Password eld.

c. Click Connect. The Matrix Switchers Control Program

is ready for operation.