Setup Guide User guide

CrossPoint / MAV Matrix Switchers • Installation
Installation, cont’d
2-6
CrossPoint / MAV Matrix Switchers • Installation
2-7
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
h
Remote port — If desired, connect a control
system or computer to the rear panel Remote
RS-232/RS-422 port.
N
Serial port defaults: RS-232, 9600 baud,
no parity, 8-bit, 1 stop bit, no flow control.
Pin Function Pin# PinFunction
1
2
3
4
5
6
7
8
9
—
TX
RX
—
Gnd
—
—
—
—
Not used
Transmit
Receive
Not used
Ground
Not used
Not used
Not used
Not used
—
TX–
RX–
—
Gnd
—
RX+
TX+
—
Not used
Transmit –
Receive –
Not used
Ground
Not used
Receive +
Transmit +
Not used
Pin Function
All Models
2412 — 3232
RS-422RS-232
TX+
TX–
RX+
RX–
Gnd
—
—
—
—
Transmit +
Transmit –
Receive +
Receive –
Ground
Not used
Not used
Not used
Not used
Matrix Sizes:
2412 — 3232
Matrix Sizes:
84 — 1616
MAV Plus 248 / 328 A
i
LAN port — If desired, connect a network WAN or LAN hub, a
control system, or computer to the Ethernet RJ-45 port.
Network connection• — Wire as a patch (straight) cable.
Computer or control system connection• — Wire the
interface cable as a crossover cable.
N
The factory default IP address is 192.168.254.254.
j
External Sync (MAV Plus) — If desired, attach an external sync
timing device to the external sync connector.
POWER
12V
0.5A MAX
LR
1
4
3
2
1
6
5
PAL
NTSC
BLACKBURST
BLACKBURST/
COLORBAR
-10dBV
+4dBu
1 2 3
ON
1 KHZ AUDIO
BBG 6 A
BLACK BURST/COLOR BAR
/AUDIO GENERATOR
EXT
SYNC
Terminate cable
or connect to
another device.
Connect to
MAV Plus.
OUT
Extron
BBG 6 A
Black Burst Color Bar
Audio Generator
Figure 2-6 — External Sync connection
k
Power — Plug the switcher into a grounded AC source.
51
96
Front Panel Configuration Port
(Matrix Sizes up to 1616, MAV Plus 32 A, and
MAV Plus 248 A)
AUDIO
VIDEO
I/O
CONTROL
ENTERPRESET
VIEW
ESC
CONFIG
ULTRA-WIDEBAND MATRIX SWITCHER WITH ADSP
™
CROSSPOINT ULTRA SERIES
12
Figure 2-7 — Front panel configuration port
l
Configuration port — If desired, connect a control system
or computer to the front panel Conguration (RS-232) port.
Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232
cable, part #70-335-01.