Installation Instruction Manual

Installation, cont’d
ISS 506 Optional I/O board • Installation
10
N
The HD-SDI and low resolution (scan converter) output boards use connectors J2A/J2B and J1. The DVI output
board uses J2A/J2B only.
4. Align one or both connector extension(s) with J1 and J2A/J2B on the main board (
e
). Gently apply
pressure to carefully mate the extension(s) with the main board (figure 8).
N
To make installation of the board easier, angle the extensions slightly away from the rear of the ISS as shown.
5
5
Figure 8 — Connector extensions