User Manual

ISM VS Output Board • Setup Guide, cont’d
ISM VS configuration menu
Using the front panel menu buttons (Menu and Next), the ISM VS configuration
menu can be accessed. From the Output Configuration screen, press Next until
reaching the #x Video Scaler menu (see the image below). Press Menu and Next
to navigate through the menus and use the front panel adjust knobs ({ [), to
change the settings as desired. Refer to the ISM 824 User Guide, online at
www.extron.com for full details.
From the default cycle press Menu repeatedly to reach the Output Configuration
menu. Press Next (enters Select Output menu) and rotate either Adjust
knob to select the Video Scaler menu. Follow the figure below to enter
each menu and use the Adjust knobs to change value as desired.
MENU NEXT
ADJUST
2
Select Ou tpu t
#3 Vid eo Scal er
Next
Menu
Output Co nfi g
#3 Vid eo Scal er
RGBHV
Output Ty pe
Rotate encoder to
adjust pixel value
Rotate encoder to
adjust refresh rate
Next
H - V -
Sync Polar ity
Next
Rotate either encoder
to change sync polarity
(H- V-, H- V+, H+ V-, H+ V+)
1024x768 60
Resolutio n
Next
Rotate either encoder
to select output type
(RGBHV, RGBS,
RGsB, YUV Bi-Level)
Next
Menu
Next
User Pres ets
#3 Vid eo Scal er
<NA> 1 2 3
Save Pre set
Next
Rotate either encoder
to select a preset to
save current settings
<NA> 1 2 3
Erase Pre set
Next
Rotate either encoder
to select a preset
to erase
Advance d C onfig
#3 Vid eo Scal er
Menu
Next
000 000
Top B lanking B ot
Next
<Off> O n
Blue Mode
Next
Off < On>
Filter
Next
Rotate either encoder
to turn encoder filter
On or Off
Off <On >
2:2 Pulld own
Next
Rotate either encoder
to turn 2:2 Pulldown
On or Off
<Off> O n
Enhanced Mod e
Next
Rotate either encoder
to turn enhanced mode
On or Off
Auto Me mories
Next
Rotate either encoder
to turn auto memories
On or Off
Off <On >
Rotate encoder to
select input
Rotate encoder to
turn On or Off
Input #2 On
Auto Image
Rotate either encoder
to turn Blue Mode
On or Off
NOTE:
Within any submenu, press the Menu button
to go directly to the top level (Output Card
Configuration) menu. If, for 30 seconds, no
button is pressed or adjust knob is rotated,
the menu times out and reverts to the default
display cycle.
Rotate encoder
to adjust top blanking
Rotate encoder to
adjust bottom blanking