User guide

3
SIS command definitions and table continues on page 4.
Resolution 50 Hz 60 Hz 72 Hz 75 Hz 96 Hz 100 Hz 120 Hz 59.94 Hz
640x480 X X X X X X
800x600 X X X X X X
852x480 X X X X X
1024x768 X X X X
1024x852 X X X X
1024x1024 X X X
1280x768 X X X X
1280x800 X X
1280x1024 X X X
1360x765 X X X
1365x768 X X X
1366x768 X X X
1365x1024 X X
1400x1050 X X
1440x900 X X
1600x1200 X X
1680x1050 X
1920x1200 X
480p X X
576p X X
720p X X X
1080i X X X
1080p X X X
1080p Sharp X
Advanced Config
Within this submenu the following settings can be adjusted: auto Image (on or off),
test pattern (selection), blue mode (on or off), auto memories (on or off), film mode
(on or off), and RGB pass-through (on or off), and full screen (on or off).
Test pattern
The test pattern submenu offers the following test patterns: split color bars, two
crosshatch patterns, grayscale, ramp, alternating pixels, crop, and four aspect ratios.
Board-specific SIS
™
commands
Alternatively, the ISM RGB board can be configured with specific Special Instruction
Set
™
(SIS) commands. The table on page 4 list some of the ISM RGB board-specific
commands. Command definitions begin below and continue on page 4. For a full list
of SIS commands refer to the ISM 824 User Guide, online at www.extron.com.
NOTE: X! = Input number, 0-8
X@ = Output number, 1-8
X1) = Mode status, 1 = on, 0 = off
X2! = Output resolution, 01 = 640x480, 02 = 800x600, 03 = 852x480, 04 = 1024x768,
05 = 1024x852, 06 = 1024x1024, 07 = 1280x768, 08 = 1280x1024, 09 = 1360x765,
10 = 1365x768, 11 = 1366x768, 12 = 1365x1024, 13 = 1400x1050, 14 = 1600x1200,
15 = 480p, 16 = 576p, 17 = 720p, 18 = 1080i, 19 = 1080p, 20 = 1280x800,
21 = 1440x900, 22 = 1680x1050, 23 = 1920x1200, 24 = 1080p Sharp