Owner manual

ISM DVI Output Board • Setup Guide, cont’d
ISM DVI configuration menu
Using the front panel menu buttons (Menu and Next), the ISM DVI configuration
menu can be accessed. From the Output Configuration screen, press Next until
reaching the #x Univ DVI menu (see the image below). Press Menu and Next to
navigate through the menus and use the front panel adjust knobs ({ [), to
change the settings as desired. For full menu details see the ISM 824 User’s
Manual, online at www.extron.com.
From the default cycle press Menu repeatedly to reach the Output
Configuration menu. Press Next (enters Select Output menu) and rotate
either Adjust knob to select the Univ DVI menu. Follow the figure below
to enter each menu and use the Adjust knobs to change value as desired.
Selec t Out put
#7 U niv DVI
Next
Input Setu p
#7 U niv DVI
Aspec t Rat io
4:3
Next
Rotate either encoder
to select Aspect Ratio
(4:3 or 16:9)
Next
H Start V
128 1 28
Rotate encoder to
adjust H(orizontal) start
Rotate encoder to
adjust V(ertical) start
Next
Total Pix Phase
1728 0 0
Rotate encoder to
adjust Total Pix value
Rotate encoder to
adjust Phase value
Next
H Activ e V
1283 10 28
Rotate encoder to
adjust H active value
Rotate encoder to
adjust V active value
Menu
Next
Outpu t Con fig
#7 U niv DVI
Rotate encoder
to adjust resolution
Rotate encoder
to adjust refresh rate
Next
1024x 768 6 0
Resol ution
Next
Menu
User Prese ts
#7 U niv DVI
<NA> 1 2 3
Save Pr eset
Next
Rotate either encoder
to select a preset to
save current settings
<NA> 1 2 3
Erase Pres et
Next
Rotate either encoder
to select a preset
to erase
Advanced Confi g
#7 U niv DVI
Next
None
Te st Patter n
Rotate either encoder
to select a test pattern
<Off> On
Blue Mode
Next
Rotate either encoder
to turn blue mode On
or Off
Off <On>
Film Mode
Next
Rotate either encoder
to turn film mode On
or Off
Next
Menu
Next
Next
Rotate encoder to
select input
Rotate encoder to
turn On or Off
Input #2 Off
Auto I mag e
Auto Memo ries
Next
Rotate either encoder
to turn auto memories
On or Off
Off <On>
Next
Input #2 O ff
Full Scree n
Rotate encoder to
select input
Rotate encoder to
turn On or Off
NOTE: Within any submenu, press the Menu button
to go directly to the top level (Output Card
Configuration) menu. If, for 30 seconds, no
button is pressed or adjust knob is rotated,
the menu times out and reverts to the default
display cycle.
Input Setup
The Input Setup submenu allows configuration of aspect ratio, horizontal and
vertical start points, total pixels, phase value, horizontal and vertical area. Rotate
the Adjust knobs as required to change values.
MENU NEXT
ADJUST
2