User`s manual

IPL T SF Series • Communication and Control
4-21
Password information
The “
]
Password:” prompt requires a password (administrator
level or user level) followed by a carriage return. The prompt is
repeated if the correct password is not entered.
If the correct password is entered, the unit responds with “
]
Login Administrator
]
” or “
]
Login User
]
”, depending
on the password entered. If passwords are the same for both
administrator and user, the unit defaults to administrator
privileges.
Error responses
When the IPL T SF interface receives a valid command, it
executes the command and sends a response to the host
device. If the unit is unable to execute the command because
the command contains invalid parameters, it returns an error
response to the host.
E10 — Invalid command
E12 — Invalid port number
E13 — Invalid parameter
E14 — Not valid for this configuration
E17 — System timed out
E22 — Busy
E24 — Privilege violation
E25 — Device not present
E26 — Maximum number of connections exceeded
E27 — Invalid event number
E28 — Bad filename/file not found
References to errors (at command descriptions on the
following pages):
10
= Commands that give E10 (Invalid command).
24
= Commands that give E24 (privilege violation) if not
administrator level.
27
= Commands that may give E27 (invalid event number).
28
= Commands that may give E28 (file not found).