User`s manual

IPL T SF Series • Communication and Control
4-9
Controlling IR devices or sending IR commands
(SFI244 only)
In order to send IR commands to IR devices via the default Web
pages, do the following:
1. Select the File Management tab and the File Management
screen (gure 4-16) is displayed.
2. Upload the IR driver to the box by clicking the Browse
button and locating the appropriate driver. The IR driver
le must be named numerically (ranging from 0 to 99).
N
File names must end with an .eir extension. (e.g., 0.eir,
24.eir, etc.)
3. Select the Configuration tab.
4. Click IR Drivers on the menu (on the left side of the
window) and the IR Drivers screen (gure 4-11) is
displayed. All uploaded IR drivers should be displayed on
this page.
Figure 4-11 — IR Driver screen
5. Click the IR driver that controls the device. A separate IR
interface screen (gure 4-12) displays the commands in the
driver.
6. Select the port to which the IR command will be sent.
7. Execute the IR command by clicking the command link.
The IR LED on the front of the IPL T SFI244 unit will blink
a green light verifying the sending of the IR command.