User`s manual
IPL T SF Series • Connection and Conguration
Connection and Configuration, cont’d
3-8
4. Select Internet Protocol (TCP/IP) from the list and click
on Properties. (If you are using Windows 2000, right-click
Local Area Connection and select Properties from the
menu, then select Internet Protocol (TCP/IP) from the
list and click on Properties again.). If Internet Protocol
(TCP/IP) is not on the list, it must be added (installed).
Refer to your Windows user’s manual or the online Help
system for information on how to install the TCP/IP
protocol.
5. Write down your current IP address and subnet mask
below. If your PC is set to “Obtain an IP address
automatically,” make a note of that, instead.
IP Address:
. . .
Subnet Mask:
. . .
6. Click on “Specify an IP address” or “Use the following IP
address” (depending on your operating system), and leave
the default gateway blank. Enter the following values:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
7. Save the changes and exit the Network setup. Reboot the
PC, if required, for the changes to become effective.
8. Launch your Web browser (Netscape Navigator or Internet
Explorer), and type “http://192.168.254.254/index.html”
in the Address eld. The IPL T SF default Web page is
displayed. Refer to “IPL T SF interface conguration”, in
this chapter, for information on conguring your unit.
9. After conguring your IPL T SF interface, repeat steps
3 and 4 and change your TCP/IP settings back to their
original conguration.
Firmware upgrades
Firmware upgrades become available as improvements
are made to the versatility and functionality of the
IPL T SF interface. These upgrades are available for download
from the Extron Web site. For information on upgrading the
rmware, see “Upgrading the rmware” in chapter 4.