User`s manual
IPL T SF Series • Connection and Conguration
now be updated to the new address, and then you can
reconnect using either Telnet or the Web to verify that the
update was successful.
Figure 3-6 — Unit response to a ping request
6. After verifying that the change was successful, issue the
arp –d command at the DOS prompt. For example:
arp –d 10.13.170.15 removes 10.13.170.15 from the arp table
or
arp –d* will remove all static IP addresses from the arp
table.
Configuring the IPL T SF using direct PC connection
This type of connection is used initially to connect to and
congure the IPL T SF unit. The unit’s default settings (IP
address, subnet mask, and [optional] administrator name and
password) must be changed in order to use the unit on an
intranet (LAN) or on the Internet (WAN).
1. Plug one end of a CAT 5, crossover Ethernet cable into
the rear panel Ethernet connector on the IPL T SF unit.
See gure 2-7 for RJ-45 connector wiring.
2. Plug the other end of the Ethernet cable into the Ethernet
port on your PC.
3. Right-click on the Network Neighborhood or My Network
Places icon on your Windows (98, 2000, NT, ME, XP)
desktop and select Properties from the menu.
3-7