User`s manual

IPL T SF Series • Connection and Conguration
Connection and Configuration, cont’d
3-6
N
In order to use this setup method, both your computer and
IPL T SF interface must be connected to the same LAN.
Or, you may use a crossover Ethernet cable to connect the
device server directly to your computer’s Ethernet card.
Use ARP to congure the IP address as follows:
1. Obtain a valid IP address for your IPL T SF interface from
your network administrator.
2. Obtain the IPL T SF unit’s MAC address (UID #) from the
label on its rear panel.
3. If the unit has never been congured and is still set for
factory defaults, go to step 4. If not, perform a Mode 4
system reset. For detailed information on reset modes, see
“Resetting the unit” in Chapter 2.
C
Your IPL T SF unit must be configured with the
factory default IP address — 192.168.254.254 —
before executing the ARP command, as described
below.
4. Access the MS-DOS command prompt, then execute the
‘arp –s’ command.
Enter the desired new IP address and the MAC address
(the MAC address is located on the rear panel’s upper
right corner) for the IPL T SF unit. For example:
arp –s 10.13.170.15 00-05-A6-00-0A-90
Figure 3-5 — Executing the ARP command
5. Execute a “ping” command by typing your new IP address
at the command prompt. For example:
ping 10.13.170.15
After issuing this command, the unit changes to the
new address and start responding to the ping requests,
as shown below. The IPL T SF unit’s IP address should