User`s manual

IPL T SF Series • Connection and Conguration
3-3
Serial connection
The IPL T SF interface can be connected to any existing A/V
product that has a serial control port.
Figure 3-2 — Typical IPL T SFI244 Serial connection
1. Connect one end of a serial cable to the rear panel COM
port connector of the interface unit. As an alternative, you
can use a 3.5 mm, 5-pole captive screw connector wired
appropriately, where available. See gure 2-8 for pin
assignments.
2. Connect the other end of the serial cable to the display or
switching device to be controlled through the interface.
IR connection (SFI244 only)
Wiring for the IR emitter is provided by the IR ports. The
IPL T SF interface provides enough current to power up to four
IR emitters with a 100 foot run each, or at least 1 at up to 4000
feet. IR control can be applied to devices such as VCRs, audio
tape players, or DVD players.
1. Connect one end of an IR emitter cable to the rear panel
IR port connector of the interface unit. See gure 3-3 for
connection options.
2. Place the head of each IR emitter over or directly adjacent
to the controlled device’s IR receiver.
Extron
IPL T SFI244
Ethernet Control
Interface
User Control &
Administrator Monitoring
Ethernet
COM1
TX
RX TX RX
COM2
LAN
00-05-A6-xx-xx-xx
POWER
12V
.5A MAX
FLEX I/O
2
1
3 4 1
IR
2
3
4
GS
GSGSG
S
CROSSPOINT 42 HVA
AUDIO/ dB
VIDEO/ dB
CONF/
SAVE
4
3
2
1
1
2
I/O
INPUTS
OUTPUTS
RS-232
Projector
Extron
Switcher
RS-232
TCP/IP
Network