User`s manual

IPL T SF Series • Installation and Operation
Installation and Operation, cont’d
2-4
Figure 2-2 — Mounting the interface on the
standard shelf
Furniture or projector mounting
In addition to using the IPL T SF unit on a rack, it can also be
furniture or projector mounted. Furniture mount or projector
mount the interface using the optional mounting kit (Extron part
#70-212-01, furniture, or Extron part #70-217-01, projector) as
follows:
1. Attach the mounting brackets to the interface with the
machine screws provided (gure 2-3).
2. If feet were previously installed on the bottom of the
interface, remove them.
3. For furniture mounting, hold the interface with the
attached brackets against the underside of the table or
other furniture. Mark the location of the screw holes of the
bracket on the mounting surface.
4. For furniture mounting, drill 3/32” (2 mm) diameter pilot
holes, 1/4” (6.3 mm) deep in the mounting surface at the
marked screw locations.
5. For furniture mounting, insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4” of the screw head
protrudes.
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
NOTE: Using screws longer
than 3/16” will damage the
unit and void the warranty.
1U Universal Rack Shelf