User guide

Mode 3

Activation Hold the Reset button in until the Power LED blinks once

(approximately 3 seconds). Release it, then immediately press it

again momentarily (for less than 1 second).

NOTE: Nothing happens if the momentary press does not

occur within 1 second.

Result Turns events on or off, depending on their current state. During

resetting, the reset LED ashes two times if events are starting and

three times if events are stopping.

Purpose and notes This mode is used for troubleshooting.

Mode 4

Activation Hold the Reset button in until the Power LED blinks twice

(approximately 6 seconds). Release it, then immediately press it

again momentarily (for less than 1 second). The Power LED blinks

four times in quick succession, conﬁrming a mode 4 reset.

NOTE: Nothing happens if the momentary press does not

occur within 1 second.

Result Reset mode 4 does the following:

• Enables ARP program capability.

• Sets the IP address back to factory IP settings.

• Sets the subnet mask back to factory default.

• Sets the gateway address back to factory default.

• Sets port mapping back to factory default.

• Turns DHCP off.

• Turns events off.

Purpose and notes Mode 4 enables you to set IP address information using ARP and

the MAC address.

Mode 5

Activation Hold in the Reset button until the Power LED blinks three times

(approximately 9 seconds). Release it, then immediately press it

again momentarily (for less than 1 second). The power LED blinks

four times in quick succession, conﬁrming a mode 5 reset.

NOTE: Nothing happens if the momentary press does not occur

within 1 second.

Result Performs a complete reset to factory defaults (except for the

ﬁrmware).

Purpose and notes Mode 5 is useful if you want to start over with control software

conﬁguration and to replace events.

IPL T PCS4 • Front Panel Features and Operation 14