User`s manual

IPL T CR48 • Communication and Control
4. If passwords were set up for the connected system, you
will be prompted to log in as Administrator or User.
Otherwise the system will respond with a <cr/lf>.
Figure 4-12— Connecting to the IP address
5. Once you are connected, you can enter serial (ASCII)
commands as desired.
6. When you are through entering commands to the interface,
type “quit” at the command prompt to quit Telnet.
Troubleshooting
For best results, make connections in the following order: turn
on the control devices (PC, laptop, etc.), then the IPL T control
interface, and lastly the output device(s) (projector lifts, screen
lifts, lighting systems, etc.).
If the output A/V device cannot be remotely controlled, check
the following:
Power connections
1. Ensure that all devices are plugged in.
2. Make sure that each device is receiving power. If the
device is receiving power, the interface’s front panel power
LEDs will light.
4-25