User`s manual

IPL T CR48 • Connection and Conguration
Configuring the IPL T CR48 using direct PC connection
This type of connection is used initially to connect to and
congure the IPL T CR48 unit. The unit’s default settings (IP
address, subnet mask, and (optional) administrator name and
password) must be changed in order to use the unit on an
intranet (LAN) or on the Internet (WAN).
1.
Plug one end of a CAT 5, crossover Ethernet cable into
the rear panel Ethernet connector on the IPL T CR48 unit.
Refer to gure 2-6 for RJ-45 connector wiring.
2.
Plug the other end of the Ethernet cable into the Ethernet
port on your PC.
3.
Right click the Network Neighborhood or My Network
Places icon on your Windows (98, 2000, NT
®
, ME, XP)
desktop and select Properties from the menu.
4.
Select Internet Protocol (TCP/IP) from the list then select
Properties. (If you are using Windows 2000, right-click
Local Area Connection and select Properties from the
menu, then select Internet Protocol (TCP/IP) from the list
and select Properties again.) If Internet Protocol (TCP/
IP) is not on the list, it must be added (installed). Refer to
your Windows user’s manual or the online Help system
for information on how to install the TCP/IP protocol.
5.
Write down your current IP address and Subnet Mask
below. If your PC is set to “Obtain an IP address
automatically,” make a note of that, instead.
IP Address:
. . .
Subnet Mask:
. . .
6. Click “Specify an IP address” or “Use the following IP
address” (depending on your operating system), and leave
the default gateway blank. Enter the following values:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
7. Save the changes and exit the Network setup. Reboot the
PC, if required, for the changes to become effective.
8. Launch your Web browser (Netscape Navigator or
Internet Explorer), and type “http://192.168.254.254/
index.html” in the browser’s Address eld. The
IPL T CR48 default Web page is displayed. Refer to
“IPL T CR48 conguration,” in this chapter, for
information on conguring your unit.
3-7