Setup guide

TLP 700MV • Setup Guide
2
TLP 700MV Setup Guide, Continued
8. Use a Phillips head screwdriver to tighten the screws. As the screws tighten, the locking arms rotate into
position behind the wall and hold the unit in place.
W
Do not overtighten the screws as this can damage the unit or the wall.
Tighten screws to
rotate locking arms.
Faceplate snaps to unit
(4 plcs ea side).
9. Do not replace the faceplate at this time as you will need access to recessed Menu and Reset buttons to
configure the unit.
TLP 700MV Front Panel Features
a
Buttons — These ten backlit push-buttons (five on either side of the screen) can be configured, using the Extron
Global Configurator software, to control commonly used functions.
b
Motion Detector — is capped with a small Fresnel lens that focuses light onto the sensor. When no motion has
been detected for a user-defined period of time, the unit goes into sleep mode. When motion is detected in the
vicinity of the panel, the screen display is restored and all buttons are active.
c
Encoder Knob — intended for volume control but it can be configured to control other functions.
d
Light Sensor — monitors the level of ambient light and adjusts the screen brightness and button backlighting.
e
LCD screen — The 800 x 480 resolution LCD screen has a touch overlay. A graphic user interface is designed
using the Extron GUI Configurator software to display buttons, text, or icons on the screen. These can be
configured for a range of user-defined functions, using the Extron Global Configurator software.
f
Speaker — A single 2 W speaker provides audible feedback for the user.
g
Reboot button — This shuts down and restarts the unit without changing any of the parameters.
LIGHTS
ON
DISPLAY
MUTE
AUDIO
MUTE
SPEECH
MUTE
AUTO
IMAGE
FREEZE
LIGHTS
OFF
SCREEN
SCREEN
HELP
?
1
4
5
6
2
3
LIGHTS
ON
DISPLAY
MUTE
AUDIO
MUTE
SPEECH
MUTE
AUTO
IMAGE
FREEZE
LIGHTS
OFF
SCREEN
SCREEN
HELP
?
7
8
9
10