Setup guide

TLP 700MV Setup Guide
68-1378-50
Rev. A 08 09
Overview
The Extron
®
TLP 700MV is a wall-mounted TouchLink
™
Panel
that provides simple and versatile configuration and control for a
range of IP Link
®
control systems.
Graphic and text objects are displayed on the screen. These objects
have system control functions associated with them and the touch
overlay allows the user to activate or regulate those functions.
The TLP 700MV communicates with the configurable IP Link controller through an Ethernet connection to an IP
Link box. Two BNC connectors allow the screen to be used to preview composite video or S-video.
N
The RJ-45 output on the rear panel of the TLP 700MV must be connected to a network switch, hub, or router that
is connected to an Ethernet LAN or the Internet. An Extron IP Link controller must also be connected to the same
network. Suggested models include:
IPL T S series (e.g. IPL T S4)•
IPL 250•
IPL T CR 48•
IPL T SFI 244 •
This guide provides basic instructions for an experienced installer to mount and perform initial configuration on
the TLP 700MV.
Mounting the TLP 700MV
The TLP 700MV can be mounted in a standard 19 inch equipment rack, using the optional Extron RM 700M rack
mounting kit (part #70-683-01). See the kit for full installation instructions.
Follow these instructions to mount the TLP 700 MV in the wall. The steps will be similar if the unit is mounted in
furniture (such as a podium or table):
1.
Determine the best location for the TLP 700MV.
W
Make certain the correct cutout dimensions are being used before
proceeding to the next step.
2.
Use the supplied template (part #68-1742-01) to mark the
wall or furniture and cut a hole.
3.
Run the network cable, two BNC video connectors,
and power supply cables inside the wall to
the hole, leaving enough slack in the cables to
connect them to the back of the TLP 700MV. The
TLP 700MV uses a 12 VDC, 1.0 A power supply
(provided).
W
See the note in the Power Supply
Connections section of the Reference
Manual for important information.
4. Unpack the TLP 700MV and remove the faceplate.
5.
Ensure all the locking arms are flush with the unit
and check that the TLP 700MV can fit into the hole. If necessary, use a rasp or a coarse file to enlarge the hole.
6
. Plug the cables into the rear panel connectors.
7. Push excess cables into the wall cavity and fit the TLP 700MV into the hole.
Power input
Video inputs (2)
LAN input