User’s Guide IN3212 and IN3214 Distribution Amplifier/Line Drivers 68-822-01 Rev.
Installation Introduction The IN3212™ and IN3214™ are high performance composite video or (for IN3214 only) S-video distribution amplifiers with gain and peaking controls. The IN3212 features 300 MHz (-3dB) bandwidth and the IN3214 features 280 MHz (-3dB) bandwidth. The compact design allows them to be installed in any convenient location. They accept NTSC, PAL, and SECAM video signals, as well as high resolution monochrome, and distribute the signal to separately buffered outputs.
Installation 3. Place the DA in the desired location or mount it in a convenient location using the optional mounting brackets. 4. Connect the input device(s) to the input connector(s). 5. Connect the output devices to the output connectors. CAUTION Ensure you are using the correct power supply, 110V or 220V, for your region. Using the wrong power supply will damage the DA. 6. Apply power to all devices and turn on the input and output devices. 7. Adjust the gain and peaking as needed.
Furniture Mounting 2. Hold the unit with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface. 3. Drill 3/32” (2 mm) diameter pilot holes, 1/4” (6.3 mm) deep in the mounting surface at the marked screw locations. 4. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4” of the screw head protrudes.
Specifications Return loss .................................... <-35dB @ 5 MHz Video output Number/signal type IN3212 ............................... IN3214 ............................... Connectors IN3212 ............................... IN3214 ............................... Nominal level ............................... Minimum/maximum levels ...... Impedance .................................... Return loss .................................... DC offset .......................................
