Operation Manual IN3056 - 1 x 4 S-Video Distribution Amplifier IN3058 - 1 x 8 S-Video Distribution Amplifier
Installation and Safety Instructions For Models without a Power Switch: The socket outlet shall be installed near the equipment and shall be accessible. For Models with 110 / 220V Power Selector: Caution: Before applying power to this unit, the voltage selector must be set to the appropriate setting to match local A/C line voltage. Improper setting of the voltage selector may cause damage to the unit and create a potential fire hazard.
Installations und Sicherheitshinweise Für Geräte ohne Netzschalter: Die Netzsteckdose soll in de Nähe des Gerätes installiert und frei zugänglich sein. Für Geräte mit 110 / 220V Spannungswähler: Achtung: Bevor Sie dem Gerät Spann ung zuführen, muß der Spannungswähler entsprechend der Spannung des lokalen Wechselspannungsnetzes eingestellt werden. Die falsche Stellung des Spannungswählers kann eine Beschädigung des Gerätes und möglicherweise ein Feuer verursachen.
CE COMPLIANCE All products exported to Europe by Inline, Inc. after January 1, 1997 have been tested and found to comply with EU Council Directive 89/336/EEC. These devices conform to the following standards: EN50081-1 (1991), EN55022 (1987) EN50082-1 (1992 and 1994), EN60950-92 Shielded interconnect cables must be employed with this equipment to ensure compliance with the pertinent Electromagnetic Interference (EMI) and Electromagnetic Compatibility (EMC) standards governing this device.
1 DESCRIPTION The IN3056 and IN3058 are high performance analog video distribution amplifiers designed for S-Video signals. These units feature separate amplification circuitry for the chroma and luma video signal components and 4-Pin mini DIN connectors for input and outputs. The IN3056 is a 1 input, 4 output distribution amplifier and the IN3058 is a 1 input 8 output distribution amplifier.
S-VHS VCR S-Video Input IN8600 Series S-Video Cables Video Monitor S-Video Input ©1996-1997 - INLINE, INC. Application Diagram IN3056 Video Monitor S-Video Input Power Supply 9V / 200 mA 2 Video Projector S-Video Input IN3056 / IN3058 OPERATION MANUAL - REV. 2.
3 OPERATION The IN3056 and IN3058 are designed to distribute and extend video signals in the S-Video (Y/C) format. These units include controls for Chroma and Luma which can be used to optimize the output signal and compensate for cable losses, extending a video signal as far as 300 feet without any degradation of the signal. The actual usable drive distance depends greatly on the type of cable used for the long cable runs.
4 SPECIFICATIONS IN3056 1 x 4 S-Video Dist. Amp. Input Connector type Chroma / Luma Signals Output Connector Type Y/C Signals Bandwidth Rise and Fall Times Controls Chroma Gain Luma Gain Dimensions Size Weight Power Consumption Accessories Included IN3058 1 x 8 S-Video Dist. Amp.. (1) 4-Pin Mini DIN Analog, 1.5V p-p max., 75 ohm impedance (4) 4-Pin Mini DIN (8) 4-Pin Mini DIN Analog Video, 75 ohm impedance 100 MHz @ -3 dB 3.5 nano seconds Adjustable: 0.9 to 1.5 Adjustable: 0.9 to 1.5 1" H x 3.5" W x 2.
5 Problem: Suggestions: The output image is not sharp enough. Vertical lines are very thin. ● Make sure you are using high quality coaxial video cables such as the Inline IN8600 Series, especially for longer cable runs. Many low cost S-Video cables are not constructed using coaxial cable and will not transmit signals well at distances over 6 to 12 feet. WARRANTY ♦ ♦ ♦ ♦ Inline warrants the equipment it manufactures to be free from defects in materials and workmanship.
