Instruction Manual
15
©2001 - INLINE, Inc. IN2200RS Operation Manual - V1.1 01/03/2001
SERIAL COMMAND EXAMPLES
The table below provides a sampling of complete serial command strings (including delimiters) and the
responses the IN2200RS might provide after receiving those commands. The bracket [ ] serial delimiters
are used for example purposes. The IN2200RS can be set to recognize four other sets of leading and end
codes: parentheses ( ), braces { }, slashes \ /, and less and greater than < >.
DESIRED FUNCTION COMMAND STRING RESPONSE
Request for current system status
[STAT0]♦
[CH=2, GAIN=1, SHARP=1, VPOS=1,
HPOS=1, FPANEL=ENABLED]
Request for screen shift status (enable / disable,
range and speed)
[STAT1]
[SSHIFT=OFF, RANGE=HI,
SPEED=HI]
Request current input and output sync format [STAT2] [CH=2, SYNC OUT=RGBHV]
Request for horizontal and vertical frequencies
(for currently selected input)
[STAT3]
[HFREQ=31,480 Hz, VFREQ=70.1 Hz]
Select input 1 [CH1] [OK]
Request current channel [CH?] [1]
Request current gain value [GAIN?] [1]
Set gain to factory default [GAIN@] [OK]
Set gain to exact value (0) [GAIN000] [OK]
Request horizontal scan rate [HSC?] [31,460 Hz]
Request vertical scan rate [VSC?] [70.1 Hz]
Request unit firmware version [INFO] [Version 1.0]
Request current vertical image position [PV?] [1]
Set vertical image position to factory default [PV@] [OK]
Set horizontal image position to a predetermined
value of 123
[PH123]
[OK]
Request current horizontal image position [PH?] [123]
Set sharpness to factory default [SHP@] [OK]
Request current sharpness value [SHP?] [126]
Request current screen shift enabled state [SS?] [OFF]
Toggle screen shift enable [SS] [OK]
Disable screen shift [SS0] [OK]
Shift image up 1 unit [PV+] [OK]
Shift image down 1 unit [PV-] [OK]
Enable screen shift [SS1] [OK]
Request current screen shift range [SSR?] [HI]
Toggle screen shift range [SSR] [OK]
Request current screen shift speed [SSS?] [FAST]
Toggle screen shift speed [SSS] [OK]
Request for current sync status
[SYNC?]
[RGBHV] (Info responses include
[RGBHV], [RGBS], [RGsB] & [MONO])
Save current setting to configuration memory [SAVE01] [OK]
Recall current setting from configuration memory [CALL01] [OK]
Error examples
] [INVALID COMMAND]
[CH3] [INVALID PARAMETER]
[CCH] [INVALID COMMAND]
Dipswitch setting conflicts - dipswitches must be changed to enable the function
Select input 1
[CH1]
[INVALID MODE-AUTO SWITCH IS
ENABLED]
Set horizontal image position to factory default [PH@]
[INVALID MODE-HPHASE DISABLED]
Set vertical image position to factory default [PV@]
[INVALID MODE-VPHASE DISABLED]