User guide

IN1604 DTP and IN1604 HD Scalers • Operation 14
Menu Overview
In the OSD menu, the firmware version is displayed in the top border. The active input
settings and output resolution are displayed in the bottom border. The OSD menu contains
nine submenus with various submenu items of adjustable settings or device information.
Use the Menu, Enter, and Navigation buttons to navigate the OSD menu.
To open the OSD menu:
1. Connect a display device to an HDMI output connector on a DTP receiver connected
to an IN1604 DTP (see figure 2,
G
on page 6) or the HDMI output connector on an
IN1604 HD (see figure 2,
I
on page 6).
2. Press the Menu or Enter button to open the OSD menu.
To navigate the OSD menu:
1. Press the Up or Down button to navigate the nine submenus. The following table shows
the nine submenus and their respective submenu items.
Submenus Submenu Items
Quick Setup Auto-Image Input Format EDID Audio Output
Resolution
Aspect Ratio Audio Mute Test Pattern
User Presets Recall Save Clear
Picture Controls Image
Position
Image Size Brightness/
Contrast
Color/Tint Detail
Input Auto-Image Input Format Film Mode Horizontal/
Vertical Start
Horizontal/
Vertical
Active
Total Pixels/
Phase
HDCP
Authorization
EDID
Output Output
Resolution
HDMI Format HDCP
Notification
Audio Audio Mute Audio Format Analog Gain/
Attenuation
Output
Format
Output
Volume
Advanced Test Pattern Screen
Saver/
Timeout
Auto-Image Aspect Ratio Auto Memory Overscan Auto Switch Factory
Reset
Communication Remote Port Contact
Mute/
Tally LED
Device Info
(Read Only)
Temperature Input
Information
Output
Information
HDCP Status Display
Information
Firmware
Version
2. Press the Enter or Right button to open submenu items.
3. Press the Up or Down button to navigate the submenu items.
4. Press the Menu button to exit a submenu item or return to the previous submenu.
To adjust a submenu item:
1. Navigate to an adjustable item and press the Enter or Right button to select the
submenu item.
2. Press the Left or Right button to select a submenu item or a specific adjustable setting
within the selected submenu item.
If the selected submenu item has multiple adjustable settings, press the Up or Down
button to select a value.
3. Press the Enter button to accept the new value.
Press the Menu button to cancel any pending changes.
To exit the OSD menu:
Hold the Menu button for 3 seconds to exit the OSD menu.