Manual

Problem: The settings on the IN1408 will not move to the desired values.

á Solution: Your settings may be outside the range of predefined modes. Switch to the User

Defined Mode to allow for a full range of settings. Select Input, Advanced, Input Mode, and

User Defined.

Problem: The input total pixels setting will not decrease.

á Solution 1: The Input H-Blanking may be set too high. Reduce the Input H-Blanking to

match the input signal.

á Solution 2: The Input Active Pixels may be set too high. Reduce the Input Active Pixels to

match the input signal.

Problem: The input active pixels setting will not increase.

á Solution 1: The Input Total Pixels may be set too low. Increase the Total Pixels setting to

match the input signal. Refer to the Advanced Input Settings Section on page 29 to make this

adjustment.

á Solution 2: The Input H-Blanking may be set too high. Reduce the Input H-Blanking to

match the input signal.

á Solution 3: The Output Resolution may be set too low. Select an Output Resolution that is

greater that or equal to the Input Active Area.

Problem: The input active lines will not increase.

á Solution 1: The Input V-Blanking may be set too high. Reduce the Input V-Blanking to

match the input signal.

á Solution 2: The Output Resolution may be set too low. Select an Output Resolution that is

greater that or equal to the Input Active Area.

Problem: The input H-Blanking will not increase.

á Solution 1: The Input Total Pixels may be set too low. Increase the Input Total Pixels to

match the input signal. Refer to the Advanced Input Settings Section on page 29 to make this

adjustment.

á Solution 2: The Input Active Pixels may be set too high. Reduce the Input Active Pixels

setting to match the input signal.

Problem: The input V-Blanking will not increase.

á Solution: The Input Active Lines may be set too high. Reduce the input Active Lines

setting to match the input signal.

If problems persist, call INLINE Technical Services at (714) 450-1800 for further assistance.