User Guide Manual

HDXP Plus Series Switchers • Operation 30
Saving a preset
Follow these steps to save the current configuration (set of ties) as a preset. The steps
show the front panel indications that result from your action.
NOTE: The illustrations for this procedure show the HDXP 3216. However, the
information applies to all HDXP models.
1. Press and release the Esc
>
button.
CONTROL
PRESET ENTER
ESCVIEW
Press the Esc
>
to clear all selections.
The button blinks once.
Figure 43. Clearing All Selections
2. Press and hold the Preset button for approximately 2 seconds, until it blinks.
PRESET PRESET
1 2
17 18
17 18
1 2
Press and hold the Preset button until it blinks.
2 seconds
= Blinking button
All input buttons with assigned presets light red.
If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Red
(Preset Assigned)
Unlit
(No Preset Assigned)
Inputs
Figure 44. Entering Save Preset Mode
In this illustration, preset 2 has already been assigned; therefore, the Input 2 button
lights red when preset mode is entered.
3. Press and release the input or output button for the desired preset number.
C O N T R O L
PRESET ENTER
ESCVIEW
17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8
INPUTS
The Enter button blinks to
indicate the need to save the
preset.
= Blinking button
Press and release an input button.
The b
utton blinks red to indicate that this
preset
number is selected but not saved.
The Preset button continues to
blink.
Figure 45. Selecting the Preset Number