User Guide Owner manual

Command/response table for Receiver SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Memory presets
Save preset
X1*
, Spr
X1*]
Command code is a comma.
Recall preset
X1*
. Rpr
X1*]
Command code is a period.
Auto memory
Disable auto memory
55*0#
Img0
]
Enable auto memory
55*1#
Img1
]
Show auto memory status
55#
X(]
Audio mute
Mute the audio
1Z
Amt1
]
Silence the audio output of the receiver.
Unmute the audio
0Z
Amt0
]
The receiver outputs audio.
Show audio mute status
Z
X(]
Audio mute status is
X(
.
Test pattern
NOTE: You must have a video input connected to the transmitter and the transmitter-Tx-to-receiver-Rx fiber cable connected for the
receiver to output a selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power
is removed.
Output color bars
1J
Tst1
]
Set the receiver to output the color bars test pattern.
Output grayscale
2J
Tst2
]
Set the receiver to output the grayscale test pattern.
Output alternating pixels
3J
Tst3
]
Set the receiver to output the alternating pixels test
pattern.
Turn test pattern off
0J
Tst0
]
Set the receiver to output the input video (no test
pattern is selected).
Show test pattern status
J
X1(]
Disable and enable return link and daisy chain
NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connected to any of outputs 2 through 6 on the DA.
Disable return link
66*0*0#
Rle*0*0
]
Disable link 2.
Enable return link to
transmitter
66*0*1#
Rle*0*1
]
Enable link 2 (default setting).
Enable daisy chain
66*0*2#
Rle*0*2
]
Enable receiver daisy chain mode.
Show return link and daisy
chain status
66*0#
0*
X2)]
Video bit depth
Set video bit depth to auto
E
V0BITD
}
BitdV0
]
Force video to 8-bit depth
E
V1BITD
}
BitdV1
]
View video bit depth
E
VBITD
} X2@]
HDCP notification
Enable notication
EN1HDCP} HdcpN1]
Disable notification
EN0HDCP} HdcpN0]
View notication status
ENHDCP}
X(]
NOTE: X( = Mute and auto memory status 0 = off 1 = on
X1^ = Horizontal and vertical position 000 through 255
X1* = Memory preset number 01 to 30
X1( = Test pattern
0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X2) = Rx link and daisy chain enable 0 = disable 1 = return link enable 2 = daisy chain enable
X2@ = Video bit depth 0 = auto 1 = 8-bit
FOXBOX Tx/Rx HDMI • Remote Control 24