User Guide Owner manual

Symbol definitions for receiver SIS commands
] = Carriage return/line feed
} = Carriage return (no line feed)
| = Pipe (can be used interchangeably with the } character)
• = Space (hard) character
E = Escape key (hex 1B)
W = Can be used interchangeably with the E character
X( = Mute/auto memory status and enable or disable status 0 = off or disable 1 = on or enable
X1! = Link and input status 0 = link or input not detected 1 = link or input detected
X1@ = Internal temperature nnnF•nnC
X1# = Transmission mode SM = singlemode MM = multimode
X1$ = Firmware version v.vv
X1% = Switch position 0 = off (right) 1 = on (left)
X1^ = Horizontal and vertical position 000 through 255
X1& = Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
X1* = Memory preset number 01 to 30
X1( = Test pattern 0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X2) =
Rx link and daisy chain enable 0 = disable 2 = daisy chain enable
1 = return link enable
X2! = Video delay (0 plus six steps at 0.25 seconds per step) 0 = 0 second
1 = 0.25 second 4 = 1.0 second
2 = 0.5 second (default) 5 = 1.25 second
3 = 0.75 second 6 = 1.5 second
X2@ = Video bit depth 0 = auto 1 = 8-bit
Command and Response Table for Receiver SIS Commands
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Video mute
Mute output
1B
Blk1
]
Blank the video output.
Unmute output
0B
Blk0
]
Output video.
Show video mute status
B
X(]
Video mute status is
X(
.
Horizontal shift
Set a horizontal position
X1^
H Hph
X1^]
Set horizontal centering to
X1^
.
Increment position
+H
Hph
X1^]
Shift the image one pixel to the right.
Decrement position
–H
Hph
X1^]
Shift the image one pixel to the left.
Show position
H
X1^]
Vertical shift
Set a vertical position
X1^
/ Vph
X1^]
Set vertical centering to
X1^
.
Increment position
+/
Vph
X1^]
Shift the image down one line.
Decrement position
–/
Vph
X1^]
Shift the image up line.
Show position
/
X1^]
List sync frequency
View input frequency
1LS
X1&
,
X1&]
List the input sync frequency as
X1&
kHz (horizontal)
and
X1&
Hz (vertical).
NOTE: X( = Mute and auto memory status 0 = off 1 = on
X1^ = Horizontal and vertical position 000 through 255
X1& = Sync frequency xxx.xx (frequency in kHz [H] or Hz [V])
FOXBOX Tx/Rx HDMI • Remote Control 23