User Guide Owner manual

r Remote RS-232 port — For serial control of the receiver, connect a host device, such
as a computer, touch panel control, or RS-232 capable PDA, to the transmitter via this
3-pole captive screw connector. See “RS-232 connections“ on page 13 to wire this
connector. See “Remote Control“ on page 17 for SIS commands and software control.
s DC power connector — Plug the included external 12 VDC power supply into this
connector. See “Power supply wiring“ on page 15, to wire the connector.
Front panel
AUDIO HDCP HDMI
CONFIG
FOXBOX Rx HDMI
21
20 22
Figure 7. FOXBOX Rx Receiver Front Panel Features
t Power LED — This LED lights to indicate that power is applied to the unit.
u Indicators —
HDMI LED — HDMI video input
HDCP LED — This LED lights when the output signal is HDCP encrypted.
Audio LED — This LED lights on the receiver when the transmitter detects a low level
audio signal for a short period of time. It returns to unlit if the audio signal drops below
the minimum threshold for a short period of time.
v Configuration port — Connect a controlling device, such as a PC, to this port via a
2.5 mm mini jack TRS RS-232 cable for RS-232 protocol control of all FOXBOX functions.
See “Front panel Configuration ports“on page 14 for more details on the adapter
cable. See “Remote Control“ on page 17 for SIS commands and software control.
The TRS RS-232 cable is included with the FOXBOX Tx HDMI transmitter.
FOXBOX Tx/Rx HDMI • Installation and Operation 11