User`s manual
FOXBOX 4G Tx/Rx • Quick Start Guide
Quick Start Guide — FOXBOX 4G Tx/Rx cont’d
QS-2 i
FOXBOX 4G Tx/Rx • Table of Contents
Chapter One • Introduction .................................................... 1-1
About this Manual .................................................................... 1-2
Cable transmission modes ..................................................... 1-4
About the FOXBOX 4G Tx/Rx ................................................ 1-4
Features ........................................................................................ 1-5
Chapter Two • Installation and Operation ................... 2-1
Mounting the Unit .................................................................... 2-2
Tabletop placement ............................................................... 2-2
Rack mounting ....................................................................... 2-2
UL guidelines ..........................................................................2-2
Mounting instructions............................................................2-3
Furniture mounting ............................................................... 2-4
Through-desk mounting ........................................................ 2-5
Connections ................................................................................. 2-6
Transmitter connections and indicators ............................... 2-6
Receiver connections and indicators .................................... 2-9
Making connections ............................................................. 2-13
DVI connector (FOXBOX 4G DVI .........................................2-13
RS-232 Over Fiber connection..............................................2-14
Alarm outputs connection ...................................................2-15
Front panel Conguration ports .........................................2-16
Power supply wiring ............................................................2-17
Operation ................................................................................... 2-18
Step 6
Connect the primary (transmitter Tx to receiver Rx)
(required) ber cable between the Tx connector on the
transmitter and Rx connector on the receiver.
N
Only the primary cable is required for video,
audio, and serial command transmission.
The secondary cable is required only to
return serial data from the controlled
device to the host device. For the return
data, the receiver must also be in normal
configuration.
N
For normal configuration with serial return,
perform step 7 and skip step 8.
For daisy chain configuration, skip step 7
and perform step 8.
Step 7a (normal configuration)
Connect the secondary ber cable between the Tx connector on the
receiver and Rx connector on the transmitter. See the drawing above.
Step 7b
Set the receiver's Mode DIP switch 1 down.
Step 8a (daisy chain configuration)
Connect the receiver's Tx output to the Rx input on
another receiver. See the drawing at right.
Step 8b
Set the receiver's Mode DIP switch 1 up.
Step 9a
FOXBOX 4G Rx VGA: Connect an RGBHV or
RGsB display to the receiver's RGB Output 15-pin
HD connector.
FOXBOX 4G Rx DVI: Connect a DVI display to the
receiver's DVI-D Output connector.
Step 10
Connect balanced or unbalanced stereo or mono
audio devices to the receiver, using the Audio
Outputs 3.5 mm mini jack.
Step 11
For serial control of the transmitter's and receiver's adjustment and
test pattern functions, connect a host device to either unit's front
panel Conguration connector via the included TRS RS-232 cable.
OPTICAL
Tx Rx
LINK
LINK
OPTICAL
Tx Rx
LINK
LINK
Transmitter
to
Receiver
with
serial
return
MODE
12
OPTICAL
LINK
LINK
OPTICAL
Tx Rx
LINK
LINK
Tx Rx
Receiver
to
Receiver
Daisy
Chain
From Transmitter
or
Daisy-Chaining
Receiver
MODE
12