User`s manual

FOXBOX 4G Tx/Rx • Remote Control
Remote Control, cont’d
3-18
FOXBOX 4G Tx/Rx • Remote Control
3-19
DDC/EDID Resolution area
The DDC/EDID Resolution area provides drop boxes that let
you manually set the DDC/EDID resolution and refresh rate.
Video Adjustment area
The Video Adjustment area provides slider controls that let you
change the following video parameters:
•ShiftHorizontal(position)
•ShiftVertical(position)
•HorizontalStart
•PixelPhase
•TotalPixels
N
When you make changes to the horizontal start, pixel
phase, or total pixels settings, the value is changed in the
transmitter.
If your PC is connected to the receiver's Configuration
port, and the receiver Tx to transmitter Rx cable is not
connected in your system or the receiver is in the daisy
chain configuration, you cannot change these values
using the control program. These slider controls are
grayed out (unavailable).
N
When you make horizontal or vertical position changes
(shift the image), the setting is changed in the receiver. It
reports the shift values to the transmitter via the optional
receiver Tx to transmitter Rx cable.
If your PC is connected to the transmitter's
Configuration port, and the receiver Tx to transmitter
Rx cable is not connected in your system or the receiver
is in the daisy chain configuration, you can still shift the
image in the control program's Video Adjustment area,
but the program cannot report the position values.
Output Configuration area
Sync Format radio buttons — The FOXBOX 4G receiver
outputsRGBHVorRGsBvideo(dependingontheinputtothe
transmitter)only.Theradiobuttonsinthisareahavenoeffect
on the FOXBOX 4G receiver. Refer to the FOX 500 User's Guide
if you are using one of those products to receive the fiber optic
signal, as those products can be configured to output RGsB
video.
Output Polarity radio buttons — Click either the Follow input
sync or Force sync to negative radio button to select the
desired video output sync polarity.
N
When you make output configuration changes, the
setting is changed in the receiver. It reports the changes
to the transmitter via the optional receiver Tx to
transmitter Rx cable.
If your PC is connected to the transmitter's
Configuration port, and the receiver Tx to transmitter
Rx cable is not connected in your system or the receiver
is in the daisy chain configuration, the program cannot
report the output sync format and polarity position
settings in the control program's Video Adjustment area.
You can change the output sync format and polarity, but
the program cannot report the changes.
Advanced Configuration area
Executive Mode buttons — The Executive Mode radio buttons
have no effect on FOXBOX 4G units' operation.
Auto Memory checkbox — Click the Auto Memory checkbox to
automaticallyapplysavedposition,horizontalstart,totalpixels,
and pixel phase settings when the sensed input resolution
changes.
Auto Image button — Click the Auto Image button to adjust the
output settings for the best image, based on the sensed input
resolution.