User`s manual

FOXBOX 4G Tx/Rx • Remote Control
Remote Control, cont’d 3-12
FOXBOX 4G Tx/Rx • Remote Control
3-13
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Information requests
Information request I
1Link
X1*
•2Link
X1*
•RGB
X1*
•Aud
X1*
•
X1(
•
X2)]
The unit responds with the current status (signal
detected) of optical link 1, optical link 2, the video input,
the audio input, the ber optic mode (singlemode or
multimode), and the device type (Tx or Rx).
N
The receiver monitors the primary (transmitter Tx to receiver Rx cable). If the PC is connected to the transmitter and the secondary fiber
cable is not installed, for the I and the S commands, the transmitter reports 1Link0 regardless of the status of the primary cable.
Show rmware version Q
X2!]
Example:
Q
1.23
]
The factory-installed rmware version is 1.23 (sample
value only).
Request part number N
60-nnn-nn
]
See appendix A for part numbers.
Request other unit's part
number
1N
60-nnn-nn
]
See appendix A for part numbers.
Show link 1 / 2 status 1S or 2S
X1*]
0 = light link not received at receiver, 1 = light received.
Show input video status 3S
X1*]
0 = video is not input to the transmitter, 1 = video is input.
Show input audio status 4S
X1*]
0 = audio is not input to the transmitter, 1 = audio is input.
Show temperature 20S
X2@]
View internal temperature in degrees Fahrenheit and
Celsius.
Command/response table for SIS commands (continued)
Command/response table for SIS commands (continued)
N
X1*
= Link/input status 0 = link or input not sensed 1 = link or input sensed
X1(
= Mode SM = singlemode MM = multimode
X2)
= Transmitter or receiver Tx = transmitter Rx = receiver
X2!
= Firmware version v.vv
X2@
= Internal temperature (Fahrenheit and Celsius) nnnF•nnC
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Resets
Reset audio
E
ZA
}
Zpa
]
Reset audio settings to default levels (0 dB gain).
Reset presets
E
ZG
}
Zpg
]
Reset (erase) all memory presets.
System reset
E
ZXXX
}
Zpx
]
Reset all settings to the factory defaults.