User`s manual

FOXBOX 4G Tx/Rx • Remote Control
Remote Control, cont’d 3-10
FOXBOX 4G Tx/Rx • Remote Control
3-11
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio output level
N
The FOXBOX 4G receiver outputs audio at the consumer level (-10 dBV) only. Refer to the FOX 500 User's Guide if you are using one of
those products to receive the fiber optic signal, as those products can be configured to output audio at the professional level.
Audio mute
Mute the audio 1Z
Amt1
]
Silence the receiver's audio output.
Unmute the audio 0Z
Amt0
]
The receiver outputs audio.
Show audio mute status Z
X!]
Audio output mute status is
X!
(0 = unmuted,
1 = muted).
Auto memory
Disable auto memory 55*0#
Img0
]
Enable auto memory 55*1#
Img1
]
Show auto memory status 55#
X!]
Auto image
Trigger auto image 55*2#
Img
]
Command/response table for SIS commands (continued)
Command/response table for SIS commands (continued)
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Test pattern
N
You must have a video input connected and the transmitter Tx to receiver Rx fiber cable for the receiver to output a selected test pattern.
The test pattern turns off if the input signal rate is changed or disconnected or if power is removed.
Output Color Bars 1J
Tst1
]
Set the receiver to output the Color Bars test pattern.
Output grayscale 2j
Tst2
]
Set the receiver to output the grayscale test pattern.
Output alt. pixels 3J
Tst3
]
Set the receiver to output the alternating pixels test
pattern.
Test pattern off 0J
Tst0
]
Set the receiver to output the input video (no test pattern
selected)
Show test pattern status J
X1^]
Disable and enable return link
N
This function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the receiver is connected to any of
outputs 2 through 6 on the DA.
Disable return link 66*0*0#
Rle*0*0
]
Disable link #2.
Enable return link 66*0*1#
Rle*0*1
]
Enable link #2 (default setting).
Show return link status 66*0#
0*
X1&]
N
X!
= Mute/auto image status 0 = off 1 = on
N
X1^
= Test pattern 0 = none 1 = Color Bars
2 = grayscale 3 = alternating pixels
X1&
= Rx Link enable 0 = disable 1 = enable (default)