User guide

FOXBOX Tx/Rx • Remote Control 28
2. Select the Com port to which your transmitter or receiver is connected. Click OK.
The FOX Extenders Control Program window appears (figure 14).
Figure 14. FOX Extenders Control Program Window
NOTE: Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for
serial command transmission. But, if you connect only one fiber optic cable,
there will be reduced control program functionality on the Rx unit. For full
functionality, install both fiber optic cables and leave the FOXBOX receiver in
normal mode (Mode DIP switch 1 down).