User guide

Command/response table for SIS commands (continued)
NOTE: X! = Mute and auto memory status 0 = off 1 = on
X1& = Test pattern
0 = none 2 = grayscale
1 = color bars 3 = alternating pixels
X1( = Rx link 0 = disable 1 = return link enable
X1* = Video shutdown interval 0 = 0 sec. (off) 2 = 0.5 sec. 4 = 1 sec. 6 = 1.5 sec.
1 = 0.25 sec. 3 = 0.75 sec. 5 = 1.25 sec.
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Audio mute
Mute the audio
1Z
Amt1
]
Silence the audio output of the receiver.
Unmute the audio
0Z
Amt0
]
The receiver outputs audio.
Show audio mute statue
Z
X!]
Audio mute status is
X!
.
Auto memory
Disable auto memory
55*0#
Img0
]
Enable auto memory
55*1#
Img1
]
Show auto memory status
55#
X!]
Auto Image™
Trigger Auto Image
55*2#
Img
]
Test pattern
NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx fiber cable connected for the receiver to output a
selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power is removed.
Output color bars
1J
Tst1
]
Set the receiver to output the color bars test pattern.
Output grayscale
2J
Tst2
]
Set the receiver to output the grayscale test pattern.
Output alternating pixels
3J
Tst3
]
Set the receiver to output the alternating pixels test
pattern.
Turn test pattern off
0J
Tst4
]
Set the receiver to output the input video (no test
pattern is selected).
Show test pattern status
J
X1&]
Disable and enable return link
NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connect to any of outputs 2 through 6 on the DA.
Disable return link
66*0*0#
Rle*0*0
]
Disable link 2.
Enable return link to
transmitter
66*0*1#
Rle*0*1
]
Enable link 2 (default setting).
Show return link status
66*0#
0*
X1^]
Video shutdown delay
NOTES: • This command mutes the output for a variable period of time when the unit detects a change in the input pixel clock.
0.5 second is the default. This feature can prevent glitches when the input video signal resolution changes.
• Front panel DIP switch 2 must be on (up) for this command to function.
Enable video shutdown
3*
X1*
# Dly
X1*]
Mute the output for an interval of
X1*
.
Example:
3*3#
Dly3
]
Mute the output for 0.75 second.
View video shutdown
3#
X1*]
The video shutdown interval is
X1*
.
FOXBOX Tx/Rx • Remote Control 25