User guide

Command/Response Table for SIS Commands
Command ASCII Command
(host to unit)
Response
(unit to host)
Additional description
Video mute
Mute output
1B
Blk1
]
Blank the video output.
Unmute output
0B
Blk0
]
Output video.
Show video mute status
B
X!]
Video mute status is
X!
.
Display Data Channel (DDC) resolution and rate (systems with DVI receivers only)
NOTE: If the receiver is a FOX 500, the rear panel DDC Resol(ution) rotary switch on the transmitter must be in position 1 for the
variables to be changeable via an SIS command. The unit returns the E14 error if the switch is in other than position 1.
Set DDC resolution
41*
X@
*
X#
# DDC
X@
*
X#]
Select a DDC Resolution.
Show DDC resolution
41#
X@
*
X#]
Show the DDC resolution.
Mode switch position (systems with FOXBOX receivers only)
Show DIP switch position
8#
X$X$]
Show the FOXBOX receiver DIP switch position.
Output sync format
Set output sync format
6*
X%
# Syn
X%]
Set the sync format.
Show output sync format
6#
X%]
Output sync polarity
Set output polarity
negative
7*1# Pol1]
Force the receiver output to always be negative.
Set polarity to the input
7*0# Pol0]
Polarity follows the video sync input to the transmitter.
Show output sync polarity
7#
X^
]
Horizontal shift
Set a horizontal position
X&
H Hph
X&]
Set horizontal centering to
X&
.
Increment position
+H
Hph
X&]
Shift the image one pixel to the right.
Decrement position
–H
Hph
X&]
Shift the image one pixel to the left.
Show position
H
X&]
Vertical shift
Set a vertical position
X&
/ Vph
X&]
Set vertical centering to
X&
.
Increment position
+/
Vph
X&]
Shift the image down one line.
Decrement position
–/
Vph
X&]
Shift the image up one line.
Show position
/
X&]
Horizontal start
NOTE: When the controlling PC is connected to the receiver, the FOXBOX can perform this command only if the receiver-Tx-to-
transmitter-Rx fiber cable is connected. The unit returns the E14 error if the Rx fiber is not connected.
Set a start position
X*
) Hst
X*]
Set the horizontal location of the first active pixel.
Example:
128)
Hst128
]
Set pixel 128 as the first active pixel.
Increment start position
+)
Hst
X*]
Increase the horizontal start location value.
Decrement start position
–)
Hst
X*]
Decrease the horizontal start location value.
Show start position
)
X*]
NOTE: X! = Mute status 0 = off 1 = on
X@ = Resolution 01 through 19. See page 20.
X# = Refresh rate 1 = 50 Hz 2 = 60 Hz
X$ = Mode switch position 0 = off (down) 1 = on (up)
X% = Output sync format 0 = RGBHV 1 = RGsB
X^ = Output sync polarity 0 = follows input 1 = force sync negative
X& = Horizontal and vertical position 000 through 255
X* = Horizontal start 000 through 255
FOXBOX Tx/Rx • Remote Control 23