User guide

Installation and
Operation
This sections details the installation of the FOXBOX Tx/Rx, including:
• Installation Overview
• Mounting the Unit
• Connections and Configuration
• Operation
Installation Overview
Follow these steps to install and set up an Extron FOXBOX transmitter and receiver system
for operation:
1. Turn off all of the equipment. Ensure that the video sources and the output display are
all turned off and disconnected from the power source.
2. Mount the transmitter and one or more receivers (see “Mounting the Unit”, below).
3. Connect the cables and configure the receivers (see “Connections and
Configuration”).
4. Plug in the power supplies, then turn on the display devices and the input devices.
Mounting the Unit
CAUTION: Installation and service must be performed by authorized personnel only.
Detailed mounting instructions can be found in the “Reference Information“ section.
Any of the 1-inch high, quarter-rack width units can be placed on a tabletop, mounted on a
rack shelf, mounted under or through a desk or other furniture, or mounted to a projector
bracket.
FOXBOX Tx/Rx • Installation and Operation 7