User guide

FOX T UWP 302 Wallplate Transmitter • FOX Extenders Control Program 36
I/O Configuration Tab
The I/O Configuration tab contains options for input and output settings. To access
these options, click the I/O Configuration tab.
Figure 27. I/O Configuration Tab
HDCP panel
The HDCP Authorized setting allows a user to turn off HDCP communication on discrete
inputs. This setting is useful for devices such as Mac computers, iPhones, iPads, and some
Windows 7 sources that will always encrypt their output if the downstream sink is capable of
HDCP. By not allowing HDCP signals on an input, most content from these sources can be
passed as a non-encrypted signal to analog and digital video outputs. In a video system that
has requirements to not transmit HDCP encrypted data (such as non-HDMI FOX Extenders),
HDCP Authorized should be turned off at the input to keep the non-HDMI FOX Extender’s
output unencrypted.
In the HDCP panel, select the On radio button to enable the HDCP Authorized setting or
select Off to disable the HDCP Authorized setting.
NOTE: Default setting: HDCP Authorized is On.
Plus Mode Transmission panel
Plus mode can support rates up to 1920x1200 @ 60Hz and 2K, with embedded audio, and
is HDCP compliant. Non-Plus mode supports rates up to 1600x1200 and 1080p, is HDCP
compliant, but does not support audio de-embedding (analog audio is still supported).
In the Plus Mode Transmission panel, click the Enabled radio button to enable Plus
mode. To disable Plus mode, click the Disabled radio button.
NOTE: Default setting: Plus Mode is Enabled.
VGA Input Video Format panel
This setting selects RGB or YUV input video format for the VGA input.
NOTE: Default setting: VGA Input Video Format is Auto.