User guide

FOX T UWP 302 Wallplate Transmitter • Installation and Operation 8
Front Panel Features
Outside-the-Faceplate Features
POWER
PC
HDMI
HDCP
AUDIO INPUT
HDMI INPUT
COMPUTER INPUT
AUDIO
B
C
D
A
Figure 3. FOX T UWP 302 Outside-the-Faceplate Features
A
LED indicators
Power LED — Lights when the device receives 12 V from an external power supply.
PC LED — Lights when a computer input is detected.
HDMI LED — Lights when an HDMI input is detected.
HDCP LED — Lights if the HDMI input signal is HDCP encrypted.
Audio LED — Lights in one of the following ways when the transmitter detects audio
on the selected input:
• Lights when an analog audio signal remains above -44 dBV but turns off after the
audio signal level drops below the threshold continuously for 10 seconds.
• Lights when the transmitter detects digital embedded audio.
B
Audio Input connector — Connect an audio source to the 3.5 mm tip-ring-sleeve
(TRS) connector.
Tip (+)
Sleeve ( )
Sleeve ( )
Ring ( - )
Tip (+)
Audio Plugs.eps
RCA Connector
3.5 mm Stereo Plug Connector
(balanced)
Sleeve ( )
Ring (R)
Tip (L)
3.5 mm Stereo Plug Connector
(unbalanced)
Figure 4. Wiring for Unbalanced Stereo Audio
C
Computer Input connector — Connect a video source to the female 15-pin HD
connector.
D
HDMI input connector — Connect a source device to the HDMI connector. This
connector can accept HDMI, DVI, or dual mode DisplayPort video signals.