User guide

FOX T UWP 302 Wallplate Transmitter • Installation and Operation 6
5. Trim back and insulate shields with heat shrink.
ATTENTION:
• To prevent short circuits, the outer foil shield can be cut back to the point
where the cable exits the cable clamp. Both braided and foil shields should be
connected to an equipment ground at the other end of the cable.
• Afin d’éviter les court circuits, le blindage en aluminium extérieur peut être
réduit jusqu’à ce que le câble sorte de la cosse de câble. Le blindage tressé et
le blindage en aluminium devraient être connectés à la masse d’un équipement
à l’autre bout du câble.
6. Connect cables to the rear panel connectors (see Rear Panel Features on page 6).
7. Mount the FOX T UWP 302 enclosure into the junction box (see Mounting on page 10).
8. Configure the FOX T UWP 302 with SIS commands (see SIS Configuration and
Control on page 15) or the FOX Extenders control program (see FOX Extenders
Control Program on page 23).
9. Install the faceplate (see Mounting on page 10).
Rear Panel Features
Tx
Rx
Rx
Tx
1
2
G
+
REMOTE
RS-232
ALARM
POWER
12V
0.6A MAX
-
RearRight Side
A
B
C
A
Fiber connector (see page 7)
B
Remote RS-232 and Alarm connector (see page 7)
C
Power connector (see page 7)
Figure 2. FOX T UWP 302 Rear Connectors from the Side and Rear Panels