User guide

FOX T UWP 302 Wallplate Transmitter • Installation and Operation 5

Installation and

Operation

This section describes procedures to cable, connect, and manually operate the

FOX T UWP 302. Topics in this section include:

• Installation Overview

• Rear Panel Features

• Front Panel Features

• Mounting and Making Connections

• Operation

Installation Overview

Install the FOX T UWP 302 into an electrical UL Listed junction box.

CAUTION: Risk of personal injury. Failure to check the items listed below may result

in personal injury.

ATTENTION : Risque de blessure. La non-vériﬁcation des éléments listés ci-dessous

peut provoquer des blessures.

ATTENTION: Failure to check the items listed below may result in property damage.

ATTENTION : La non-vériﬁcation des éléments listés ci-dessous peut provoquer des

dommages matériels.

1. Prepare the mounting surface

• Ensure there are no utility cables or pipes at the intended location that might be

damaged or cause injury when installing the device.

• Check that the installation meets building, electrical, and safety codes.

• Ensure there is sufficient space behind the device.

• Choose a location that will allow cable runs without interference.

NOTES:

• Cables may need to be installed in the wall or conduits before installation.

• For junction boxes, refer to the manufacturer for more installation

requirements.

2. Cut a hole in the mounting surface.

3. Install the junction box according to the junction box installation instructions.

4. Prepare and pull the cables through the junction box.

TIP: Secure cables with clamps or ties to provide strain relief.