User guide

FOX T USW 203 Universal Switcher • Installation 4
Installation
This section describes information for connecting and wiring the FOX T USW 203. Topics in
this section include:
• Installation Overview
• Rear Panel Features
• Connection Details
Installation Overview
Follow these steps to install and set up an Extron FOX T USW 203 in a fiber optic system:
1. Turn off all of the equipment. Ensure that the video sources and output display are all
turned off and disconnected from the power source.
NOTE: For proper equipment cooling, do not stack units in a rack.
2. Mount the switcher (see Mounting on page 38).
3. Connect the cables (see Rear Panel Features below).
4. Configure the switcher (see SIS Configuration and Control on page 13 or FOX
Extenders Control Program on page 21).
Rear Panel Features
FOX T USW 203
RS-232CONTACT
RS-232
OVER FIBER
AUDIO
HDMI
HDMI
LOOP-THRU
ALARM
REMOTE
Tx Rx
Tx Rx
OPTICAL
INPUTS
1
POWER
12V
0.8 A MAX
2
3
LINK LINK
GT
xRxG12 123G
RGB/R-Y, Y, B-Y
OUTPUTS
J B D E F G H IA C
A
Analog video connector (see page 5)
B
Analog video loop-through
connector (see page 5)
C
HDMI input connectors (see page 5)
D
Audio input connector (see page 5)
E
HDMI switched output connector
(see page 5)
F
Fiber optic connector (see page 6)
G
RS-232 and Alarm Over Fiber
connector (see page 6)
H
Contact closure connector (see page 7)
I
Remote RS-232 connector (see page 7)
J
Power connector (see page 7)
Figure 2. FOX T USW 203 Rear Panel Features