User Guide User Manual

FOX SW8 • Reference Information 20
Reference
Information
This section provides a procedure for installing button labels and mounting instructions for
the FOX SW8.
• Button Labels
• Mounting the Unit
Button Labels
Use either blank 8-button strips in figure 22 on the next page or the Button Label
Generator software (see Button Label Generator Program on page 18).
Installing Labels in the Switcher Buttons
Install new labels in the switcher front panel buttons as follows:
1. Make new labels and cut them out.
NOTE: For best results, print or copy on transparent or translucent material.
2. Remove the button from the switcher; use a small, flat bladed screwdriver such as an
Extron Tweeker to gently pry a button out from the front panel (see figure 21, below).
TEXT
Separate the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Base
Button Label
Clear Lens
Figure 21. Illuminated Button Label Replacement
3. Locate the notch in the corner of one side of the clear button cap lens.
4. Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of
the small screwdriver into the corner notch and gently twist the blade.