User Guide User guide

FOX II DP Transmitter and Receiver • Remote Control
36
e Tx Output radio buttons — Select among the available radio buttons to
define the function of the receiver Tx LC connector; either:
Enable Fiber Out — Routing RS-232 over fiber to the transmitter
Disable Fiber Out — No function
NOTE: The disable fiber out function is primarily used and recommended when the
transmitted signal is routed via a FOX 500 DA6 and the receiver is connected to
any of outputs 2 through 6 on the FOX DA.
f Return Audio Input Gain slide control — Click and slide the
Return Audio Input Gain slide control to vary to select the input
audio gain or attenuation value of the audio returned to the transmitter,
from -18 dB to +10 dB in 1.0 dB increments.
NOTE: As an alternative, you can also either:
• Click the up arrow ( ) and down arrow ( ) buttons to step the
level up and down.
• Click and highlight the value displayed in the dB field ( )
and type in the desired numeric level.
g Mute buttons — Click the Mute buttons to toggle the following mute
functions on and off:
DisplayPort Mute — Mute the signal on the DisplayPort Output port.
Analog Mute — Mute the signals on both analog audio output ports.
Mute All — Mute the signals on the DisplayPort Output port and both analog audio
output ports.
Hardware > Unit Information screen (both units)
The Unit Information screen (see figure 21) provides general information about the
connected unit. Select this screen by clicking the Unit Information subtab from either the
Device Name or Reset Device screen or Hardware > Unit Information from one of the
Configuration screens.
Figure 21. Unit Information Screen