User Guide User guide

FOX II DP Transmitter and Receiver • Remote Control
34
c Video Mute button — Click this button to toggle the video mute on and off
for the transmitter Loop-through output port. Video mute sends black video
while maintaining sync timings from the input video signal. Embedded audio continues
to be output.
d Sync Mute button — Click this button to toggle the video mute on and off
for the transmitter Loop-through output port. Sync mute disables the sync
output, allowing the display to go blank and, eventually (depending on the timeout
parameters set in the connected display) go into standby or sleep mode. Embedded
audio is also muted.
NOTE: Video Mute cancels Sync Mute and Sync Mute cancels Video Mute.
e Video Test Pattern drop-down box — Click the Video Test
Pattern drop-down box to select from the available test patterns,
shown at right, for the transmitter to send to the receiver on the
fiber cable. Or select Off to transmit the digital video input on the
DisplayPort input port.
f Audio Format radio buttons —
Auto Detect radio button — Transmit the embedded
digital audio if detected, otherwise transmit analog
audio.
Digital radio button — Transmit the embedded digital audio.
Analog radio button — Transmit the analog audio.
g Analog Input Gain slide control — Click and slide the Analog Input
Gain slide control control to vary to select the input audio gain or
attenuation value on the analog input only, from -18 dB to +10 dB in
1.0 dB increments.
NOTE: As an alternative, you can also either:
• Click the up arrow ( ) and down arrow ( ) buttons to step the
level up and down.
• Click and highlight the value displayed in the dB field ( ) and
type in the desired numeric level.
h DisplayPort Mute button — Click this button to mute and unmute the
audio embedded in the DisplayPort loop-through output.