User Guide User guide

FOX II DP Transmitter and Receiver • Installation and Operation
17
Operation
After the transmitter, all receivers, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, verify that the cables are routed and
connected properly, and that all display devices have identical resolutions and refresh rates.
If your problems persist, call the Extron S3 Sales & Technical Support Hotline. See the
contact numbers on the last page of this guide for the Extron office nearest you.
To take advantage of the various adjustments and test patterns available in the FOX II DP,
you need to connect a computer or other USB-capable device to the front panel
Configuration port or a RS-232 capable device to the rear panel Remote RS-232 port on
the unit to be addressed. Operate the connected device using either SIS commands or the
Product Configuration Software (see Remote Control on page 18).