User Guide User guide

FOX II DP Transmitter and Receiver • Installation and Operation
6
Installation and
Operation
This section details the installation of the FOX II DP transmitter and receiver system,
including:
• Installation Overview
• Connections
• Indications and Operation
Installation Overview
Follow these steps to install and set up an Extron FOX II DP transmitter and receiver system
for operation:
c Turn off all of the equipment. Ensure that the video sources and the output display are
all turned off and disconnected from the power source.
NOTE: For proper equipment cooling, do not stack units in a rack.
c Mount the transmitter and receiver (see Mounting the Units on page 41).
c Connect the cables and configure the receivers (see “Connections,” below).
c Plug in the power supplies, then turn on the display devices and the input devices.
Connections
Transmitter Connections and Controls
Rear panel
FOX II T DP
DISPLAYPORT LOOP THRU
RS-232
RS-232
IR
ALARM
Tx Rx Tx Rx 1 2GTx RxG
POWER
12V
1.2 A MAX
OPTICAL
LINK LINK
RxTx
LR
LR
INPUTS
AUDIO
AUDIO
RETURN OUT
REMOTEOVER FIBER
1 2 76
84 53
9
Figure 2. FOX II DP Transmitter Rear Panel Connectors
a DisplayPort input port — Connect a digital video input to this DisplayPort
DISPLAYPORT
connector.
The FOX II T DP also accepts embedded digital audio on this connector.
b Loop-through output port — If desired, connect a local monitor to this
LOOP THRU
DisplayPort connector.