User Guide User Manual

FOX 3G DVC • Installation 9
• Select the Yes, this time only radio button if you want your computer to
connect to Windows Update only this one time.
• Select Yes, now and every time I connect a device if you want the computer to
automatically connect to Windows Update every time the DVC is connected to this
USB port.
• Select No, not this time if you do not want the computer to connect to Windows
Update at this time (for example, if the driver is already on your computer).
3. Click Next. On the next screen, make sure that the Install the software
automatically (Recommended) radio button is selected, then click Next (you do not
need to insert a disc).
Figure 8. Selecting the Radio Button to Install the USB Driver Automatically
Your computer locates the driver needed for it to communicate with the FOX 3G DVC
via the USB port.
4. When the Completed screen appears, click Finish to close the wizard.
NOTE: This wizard appears only the first time you connect the DVC to each USB
port. You do not see the wizard again unless you connect the DVC to a
different USB port on your computer.
5. Configure the DVC as desired, using SIS commands (see the “Using SIS Commands”
section for more information).